Comply with IEEE 802.3 10BASE-T, 802.3u 100BASE-TX, 100BASE-FX Ethernet Standards

Provide one 10/100BASE-T port with RJ-45 connector, one 100BASE-FX port with SC connector supporting single-mode fiber

Provide Dip Switch to setting: Fiber (FDX/HDX), UTP (Auto negotiation/Manual), Speed (10/100M), duplex (Half/Full), LLR (Enable/Disable), LLCF (Enable/Disable)

Front panel Diagnostic LED Indications

Extend single-mode fiber optic distance up to 100km

Provide 19” system chassis for up to 16-converter with Redundant Power supply for optional expansion use

Support LLCF (Link Loss Carry Forward, Link Pass Through)Provide Dip Switch to setting: Fiber (auto/manual), LLR (Enable/Disable)

Monitor the status of duplex/ link for FX, duplex/ speed/ link for TX via management module (MOD-MCSNMP) through Media Converter Chassis System (RP-MCR116)

Set FX duplex, TX Auto/Manual, TX force duplex, TX force speed, LLCF on/off, FX LLR on/off, ports on/off via the MOD-MCSNMP through RP-MCR116

Provide link down source port information